Briggs & Stratton 074001 manuel dutilisation Higher than the CFM or pressure supplied by

TROUBLESHOOTING

PROBLEM	CAUSE		CORRECTION
	1.	Prolonged excessive use of air.	1.	Decrease amount of air used.
	2.	Compressor is not large enough for air	2.	Check the accessory requirement. If it is
		requirement.		higher than the CFM or pressure supplied by
Compressor is not				your air compressor, you need a larger
				capacity air compressor.
supplying enough air to
	3.	Hole in hose.	3.	Check and replace if required.
operate accessories.
	4.	Check valve restricted or leaks air.	4.	Remove and clean or replace check valve.
	5.	Restricted air intake filter.	5.	Tighten fittings. Clean or replace air intake
				filter (see page 13).
	1.	Motor overload protection switch has	1.	Let motor cool for 15 minutes. Press RESET
		tripped.		to reset overload switch.
	2.	Tank pressure exceeds pressure switch	2.	Motor will start automatically when tank
		“cut-in” pressure.		pressure drops below “cut-in” pressure
				setting.
	3.	Loose electrical connections.	3.	Check wiring connection inside pressure
				switch and terminal box area.
	4.	Possible defective motor or starting	4.	Have checked by a trained service technician.
		capacitor.
	5.	Pressure release valve on pressure	5.	Drain pressure by setting ON/AUTO - OFF
Motor will not run.		switch has not unloaded head pressure.		switch to OFF. If the valve does not open,
				replace pressure switch.
	6.	Fuse blown, circuit breaker tripped.	6A.	Check fuse box for blown fuse and replace as
				necessary. Reset circuit breaker. DO NOT use
				a fuse or circuit breaker with higher rating
				than that specified for that branch circuit.
			B.	Check for proper fuse. Use a time delay fuse.
			C. Check for low voltage conditions and/or
				proper extension cord.
			D. Disconnect all other electrical loads from
				circuit used by air compressor OR operate
				air compressor on dedicated branch circuit.

16