Installation
Save These Instructions
This manual contains important instructions that should be followed during installation and maintenance of the generator and battery.
Introduction
Thank you for your purchase of a Briggs & Stratton Home Generator System. This product is intended for use as an optional standby system which provides an alternate source of electric power and to serve loads such as heating, refrigeration systems, and communication systems that, when stopped during any power outage, could cause discomfort or the like. This product does not qualify for emergency standby as defined by NFPA 70 (NEC).
This manual is an important document and should be retained by the owner after installation has been completed.
This manual contains installation, startup and adjustment instructions for a Home Standby Generator that supplies 120/240 Volt, single phase, 60Hz devices. The Home Standby Generator may be operated on LP vapor or natural gas fuel.
Every effort has been made to ensure that the information in this manual is both accurate and current. However, the manufacturer reserves the right to change, alter or otherwise improve the generator at any time without prior notice.
Briggs & Stratton has made every effort to provide for a safe, streamlined and
Only current licensed electrical and plumbing contractors should attempt Home Standby Generator installations. Installations must strictly comply with all applicable codes, industry standards and regulations.
Customer Responsibilities
•Read and follow the instructions given in this manual, especially the section regarding selecting essential circuits.
•Follow a regular schedule in maintaining, caring for and using your home generator, as specified in this manual.
Installer Responsibilities
•Read and observe the safety rules.
•Install only an UL approved transfer switches that is compatible with the home generator.
•Read and follow the instructions given in this Installation,
IMPORTANT: If operating the generator below 40°F, it is recommended that a battery warmer be installed. If operating
the generator below 32°F, a battery warmer must be installed. This item is available at your local servicing dealer.
For the Home Owner:
To help you make informed choices and communicate effectively with your installation contractor(s),
Read and understand Owner Orientation in this manual before contracting or starting your home generator installation.
To arrange for proper installation, contact the store at which you purchased your Briggs & Stratton home generator, your dealer, a licensed electrician or your utility power provider.
The home generator warranty is VOID unless the
system is installed by licensed electrical and plumbing
professionals.
The Emission Control System for this generator is warranted for standards set by the U.S. Environmental Protection Agency and by the California Air Resources Board (CARB).
For the Installing Dealer/Contractor:
For most applications, the Installation manual contains all the information required to properly install and start the home generator. This Operator’s Manual describes essential circuit selection, routine operation and owner maintenance procedures.
If you need more information, call (800)
Owner Orientation
This section provides home generator owners with the information necessary to achieve the most satisfactory and cost effective installation possible.
The illustrations are for typical circumstances and are meant to familiarize you with the installation options available with your home generator. A thorough understanding of these options will provide fundamental control over the cost of your installation, as well as ensure your final satisfaction and security.
Federal and local codes, appearance, noise levels, fuel types, and distances are the factors that must be considered when negotiating with an installation professional. Remember that as the distance from the existing electrical service and gaseous fuel supply increases, and the number of 90 degree bends in the fuel supply increases; equal compensations
in piping and wiring materials must be allowed for. This is necessary to comply with local codes and overcome electrical voltage drops and gaseous fuel pressure drops.
The factors mentioned above will have a direct affect on the overall price of your home generator installation.
NOTE: In some areas you may need to acquire electrical permits for installing the home generator, building permits for installing gas lines, and permits for noise allowances. Your installer should check your local codes AND obtain the permits before installing the system.
