Section Assembly

3

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-888-611-6708.If calling for assistance, please have the model, revision, and serial number from the data tag available. See “Know Your Generator” for data tag location.

Remove Generator From Carton

1.Set carton on a rigid flat surface with “This Side Up” arrows pointing upward.

2.Carefully open top flaps of shipping carton.

3.Cut down corners of carton from top to bottom and lay that side of carton down flat.

4.Remove all packing material, carton fillers, etc.

5.Roll generator out of shipping carton.

Attach Handle

You will need two 1/2” or 13 mm wrenches to attach the handle.

1.Attach handle to right side of generator frame (viewing unit from front), as shown in Figure 1, with a 60 mm capscrew, flat washers, nylon washers, and lock nut.

Figure 1 — Attach Handle

 

Handle Pin

Lock Nut

 

Flat Washers

60mm Capscrew

 

Nut

 

Washer

 

Handle Bracket

 

Nylon Washer

 

Nylon Washer

 

Handle Bracket

 

Washer

Handle Pin

60mm Capscrew

 

NOTE: DO NOT overtighten. Handle must be able to move up and down freely.

2.Raise handle and insert handle pin to move generator.

6

Page 6
Image 6
Briggs & Stratton 30237 owner manual Assembly, Remove Generator From Carton, Attach Handle