Tension Pulley
Belt
Tension Spring
Mounting Stud
Figure 20
Figure 21 | Rear Access Panel Bolts |
|
Tension Spring
Unhooked
Drive Pulley
Figure 22
30 TOW-BEHIND DR® FIELD and BRUSH MOWER
6.Using a 9/16" Wrench, remove the top Nut from the Belt Tension Spring Mounting Stud (Figure 20).
7.Using a Hooked End Pulling Tool, remove the Belt Tension Spring from the Mounting Stud by hooking the Tool in the Spring End and pulling the Spring up and over the Stud
8.Using a 7/16" Wrench or Socket, remove the two (2) Bolts and Lock Washers that retain the Rear Access Panel on the Mower (Figure 21) and remove the Panel.
9.Slip the old Drive Belt from the Drive Pulley (Figure 22) and from the Pulley beneath the Engine at the Rear of the Mower.
10.To install the new Belt, follow the above procedure in the reverse order making sure that the Belt is on the inside of the Tension Pulley (Figure 20).
NOTE: Use one of the extra Cable
