Briggs & Stratton FIELD and BRUSH MOWER Throttle/Choke Cable - 17 HP Kawasaki Tool Needed, Pull

4. Using a Blade Screwdriver or 5/16" Nut Driver, loosen the Throttle Cable Clamp Bolt (Figure 9) and slip the Cable Sheath behind the Clamp.

5. Pull the Cable (Figure 9) as far as possible. This will move the Engine mechanism into the Choke position.

6. Tighten the Cable Clamp Bolt while holding the Cable in the Choke position.

Pull

Cable Clamp Bolt Cable Clamp

Cable Clamp

Figure 9

Return Spring “Z”-Bend

Cable

Clamp

Pull

Cable Clamp Bolt

Pivot Arm

Figure 10

Throttle/Choke Cable - 17 HP Kawasaki

Tool Needed:

•Phillips Screwdriver, or Blade Screwdriver, or 5/16" Nut Driver

1.Route the Throttle Control Cable from the Tow Bar behind the Fuel Tank straps (Figure 7 on page 17).

2.Move the Throttle Control to the Choke position on the Remote Control Panel.

3.Loop the end of the Return Spring over the “Z”- Bend of the Throttle Cable (Figure 10).

4.Insert the “Z”-Bend of the Cable end into the top hole in the Throttle Pivot Arm on the side of the carburetor (Figure 10).

5.Using a Screwdriver or Nut Driver, loosen the Throttle Cable Clamp Bolt (Figure 10), and slip the Cable Sheath behind the Clamp.

6.Pull the Cable (Figure 10) as far as possible. This will move the Pivot Arm into the Choke position.

7.Tighten the Cable Clamp Bolt while holding the Cable in the Choke position.

18 TOW-BEHIND DR® FIELD and BRUSH MOWER