Brinly-Hardy PA-48 BH, PA-40 BH owner manual Tube Assembly, Figure, Tine Assembly, 10 5

ASSEMBLY

Figure 5 TUBE ASSEMBLY

5a. Assemble Plugging Spoons (9) to each welded plate (side opposite welds) of all the Tube Assemblies (12 and 13) as shown. For PA-48H, pre-assemble Hex Bolts (20) and Flat Washers

(24). NOTE: PA-40BH does not use Flat Washers. Install the Bolt (and Washer Assemblies) through Plugging Spoons and secure with Lock Nuts (28).

IMPORTANT Rounded part of spoon fits

against the tube to lock in place.

5b. Insert a Nylon Bearing (15) into each end of the tube assemblies.

(24)

Flat Washer, 5/16"

Qty. 32 used on PA-48 BH ONLY!

15

(28)

Lock Nut, 5/16"

Qty. 24 for PA-40 BH

Qty. 32 for PA-48 BH

9

28

13

24

20

15

		(15)	(20)
Nylon Bearing, 3/4" I.D.			Hex Head Bolt, 5/16" x 3/4"
	Qty. 6 for PA-40 BH		Qty. 24 for PA-40 BH
	Qty. 8 for PA-48 BH		Qty. 32 for PA-48 BH

Figure 6		TINE ASSEMBLY	One or more Machinery Bushings as required to
6a. The End Tube Assemblies (12) have one			eliminate any side play in axle assembly.
			26
plate approximately 1-1/8" from the end of the
			12	15
tube. The Center Tube Assemblies (13) have
each plate approximately 2-3/4" from the end of				26
the tube.
				13
6b.	Place a Machinery Bushing (26) over Axle			26	12
Assembly (10). Insert Axle Assembly through
					26
Right Side Plate and install in the following order:
• End Tube Assembly (12) with short hub end
	next to side plate.
•	Machinery Bushing (26).
• Center Tube Assembly (13).

10

5

For PA-48 BH only:

•Center Plate (33) and then another Center Tube Assembly (13).

For all models:

•Machinery Bushing (26).

•End Tube Assembly (12) with short hub end next to side plate.

•One or more Machinery Bushings (26) as required to eliminate any side play in axle assembly.

L-1762 Rev. E

	Make sure Nylon Bearings
IMPORTANT
	(15) are inside Tube

Assemblies (Installed in Step 5b)

(26)

Machinery Bushing, 3/4"

Qty. 6

8