Britax Baby Accessories manual Basic Base Functions, Isofix Connectors, Isofix Protective Cap

Basic Base Functions

ISOFIX Connectors

The ISOFIX connectors should be in either ISOFIX Installation Mode (fig. A) or Vehicle Belt Installation Mode (fig. B).

A

B

ISOFIX Protective Cap
The ISOFIX Protective Cap must be used
when base is installed using vehicle belts.
To attach Protective Cap, align with
connectors as shown, then press until
positive click is heard (fig. C).
To remove Protective Cap, squeeze green
and red ISOFIX release buttons, then pull
cap off.	C

Basic Base Functions

Vehicle Belt Installation Spacers
Due to varying locations of vehicle belt
anchor points, the Vehicle Belt Installation
Spacers must be used for a secure vehicle
belt installation.
To use spacers, insert one spacer on each
side of anti-rebound bar (fig. C) before
installing base with a vehicle belt.	C

IMPORTANT: Spacers must be removed for

ISOFIX installation.

Recline Adjustment
To adjust recline level, press both tabs
while moving the recline block up (fig. D)
or down (fig. E), to desired location.
IMPORTANT: Use level line indicator on
carrier to assist with achieving correct
recline angle.
	D
If further recline adjustment is necessary,
use a tightly rolled towel.
WARNING: Only raise carrier as described
above. Do not raise the carrier off of the
front edge of the vehicle seat; doing so will
reduce the protection for your child.
	E

18 19