Base Installation
Base Installation
ISOFIX Installation
•Figure A illustrates a typical base ISOFIX installation.
•Remove carrier before installing base.
•Verify that your vehicle is equipped with ISOFIX anchors. If ISOFIX anchors are not available, you must use vehicle belt installation methods.
1Place ISOFIX connectors in ISOFIX Installation Mode.
•Remove ISOFIX Protective Cap and spacers, if installed.
2Place foot prop in Installation Mode.
•Always use foot prop when base is installed in vehicle!
3Line up ISOFIX connectors on base with anchors in vehicle (fig. B).
•If it is difficult to line up ISOFIX connectors with ISOFIX anchors, use Insertion Aid for assistance, as instructed on page 23.
A |
B
5Adjust foot prop so that it is against the vehicle floor.
WARNING: Never use foot prop to raise base above vehicle seat surface. Doing so will reduce the stability of the base.
6Attach carrier to base.
•Verify that the green indicator band on the release button is fully visible.
•Verify that the red line on carrier is level with the ground.
•If angle is not correct, remove carrier and base, then adjust recline angle as directed on page 19.
7Adjust carrier handle to
Removal
Squeeze green and red ISOFIX release buttons on each connector (fig. D), then pull base away from vehicle seat.
IMPORTANT: Always store ISOFIX connectors
DIndicatorIndicator
D
4Engage ISOFIX connectors by pressing base onto ISOFIX anchors, until a positive click is heard (fig. C).
•Visual confirmation can be made using the green ISOFIX indicators. Green indicator must be fully visible from the side when installed properly (fig. D).
•Pull base away from vehicle seat to further verify attachment.
C 
when not in use. See page 18.
ISOFIX Guides
If necessary, use ISOFIX Guides to assist with base attachment to ISOFIX anchors.
To use, clip ISOFIX Guide onto each ISOFIX connector that will be used for installation of base (Fig. E).
ISOFIXISOFIX GuideGuide
E
22 | 23 |
