MODEL EI5936SS
8.Attach foam seals to plenum and frame, around the plenum openings.
INSTALL THE HOOD
(All Hoods - Steps 9 thru 25)
ELECTRONICS |
MOUNTING |
BRACKET |
9.Remove tape holding electronics mounting bracket to hood. Remove (3) screws on top of hood chassis and set screws aside. Rotate electronics mounting bracket as shown and secure to hood with same (3) screws.
Page 6
10.Remove the protective plastic film covering the decorative flue and the hood at this time.
11.Remove the grease filter by pulling down the metal latch tab and tilting filter downward.
12.Carefully place glass canopy on top of the hood. Align nuts on glass canopy with holes inside the hood. Attach canopy with (4) .188” x .250” long flat head screws. Tighten screws securely but DO NOT OVERTIGHTEN.
13.Align the keyhole slots on the bottom of the frame assembly with the (4) mounting screws on the top of the hood (partially tightened). Slide the hood so the screw heads are seated entirely on mounting screws and that hood is level. Then tighten screws completely.
14.Install (1) 4mm x 12mm long screw into the lower frame and hood to secure.
