Broan EI5936SS For Ducted Hood, For Non-Ducted Hood, Non-Duct Hood Only, 6” ROUND STEEL DUCT

MODEL EI5936SS

Page 7

15.Remove wiring cover and connect house wiring to hood wiring – black to black, white to white, green to green. Re- attach wiring cover.

6” ROUND STEEL DUCT
(Ducted Hood)
6” ROUND FLEXIBLE
METAL DUCT	DECORATIVE
(Non-Ducted Hood)	FLUE
DUCT LENGTH

16.FOR DUCTED HOOD

Measure, cut, and install steel duct between hood’s duct connector and duct rough-in in ceiling. Use duct tape to make all joints secure and air tight.

FOR NON-DUCTED HOOD

Measure, cut, and install flexible metal duct between hood’s duct connector and non-duct plenum. Use duct tape to make all joints secure and air tight.

CAUTION

Do not use plastic duct.

17.NON-DUCT HOOD ONLY

Attach filter tray to bottom of hood using (4) .188” x .375” mounting screws.

18.NON-DUCT HOOD ONLY

Snap in 2-non-duct filters into filter trays by engaging filter tab on side, rotating upward, and pressing firmly on (2) filter clips.

19.Reinstall grease filter by aligning rear filter tab with slots in the hood. pull down the metal latch tab, push filter into position and release. Make sure filter is securely engaged after installation.

4mm x 12mm

SCREWS

3mm x 5mm

SCREWS

20.Carefully place the (2) upper flue sections on the hood frame.

Note that the louvers should be on top for a non-ducted application, and on the bottom for most ducted applications. Make sure that the clearance holes (larger) are in front of the attachment holes (smaller) where the two flue halves meet.

While gently pushing the two flue sections together and sliding them to the top of the frame, attach the flue sections together through the top attachment slots and into the upper frame mounting holes using (2) 4mm x 12mm screws.

21.Gently push the lower parts of the flues together and complete attachment using (6) 3mm x 5mm screws.