MODELS EW5830SS • EW5836SS
10.Slide the upper decorative flue section into the lower decorative flue section.
NOTE
For ducted applications, the louvers on the upper flue should be hidden by positioning the louvers down, inside of the lower flue.
11.Carefully place the upper/lower flue assembly into the recessed area of the hood.
12.Slide the upper flue upward until it is aligned with its mounting bracket. The bracket should be inside the flue. Secure the upper flue to the upper flue mounting bracket using (2) 4mm x 12mm mounting screws.
NOTE
Page 5
INSTALL THE HOOD (Non-Ducted Hoods Only)
NON-DUCT KIT MODEL RKE58 CONTENTS
| 2 MOUNTING |
| SCREWS |
| (4mm x 38mm |
| Cross Recessed |
Pan Head) | |
ASSEMBLY | 8 MOUNTING |
| SCREWS |
| (.188” x .375” |
| Cross Recessed |
| Flat Head) |
| FILTER TRAYS |
FLEXIBLE DUCT |
|
|
NOTE
Ceiling
Flush with the ceiling
Upper flue mounting
bracket slots
C
L
Center of
installation
1.Center the
(2) 4mm x 38mm mounting screws. Note: Drywall anchors may be needed (not included).
2.Tighten the screws completely. Make sure that the
3.Remove damper flaps from damper / duct connector and discard flaps.
4.Remove the protective plastic film covering the decorative flue and the hood at this time.
5.Remove the grease filters by pulling down the metal latch tab and tilting filters downward to remove.