Broan EW5836SS NON-DUCT 6” ROUND PLENUM FLEXIBLE METAL DUCT DUCT LENGTH DECORATIVE, Flue, Page

MODELS EW5830SS • EW5836SS

6.Align the two outer keyhole slots on the hood with the mounting screws that were partially tightened into the wall framing. Ensure that hood is seated entirely on mounting screws and that hood is level.Then tighten screws completely.

7.Install (2) 4mm x 38mm long screws into the holes inside the hood and tighten them securely.

8.Attach (2) filter trays to bottom of hood using (8) .188” x .375” mounting screws.

9.Snap in 2-non-duct filters into filter trays by engaging filter tab on side, rotating upward, and pressing firmly on (2) filter clips.

10.Reinstall grease filters by aligning rear filter tab with slots in the hood. Pull down the metal latch tab, push filters into position and release. Make sure filters are securely engaged after installation.

Page 6

NON-DUCT 6” ROUND PLENUM FLEXIBLE

METAL DUCT DUCT LENGTH

DECORATIVE

FLUE

11.Measure and install section of flexible metal ductwork (included with RKE58) to hood duct connector and bottom of non-duct plenum. Use duct tape to make all joints secure and air tight.

CAUTION

Do not use plastic duct.

12.Plug power cord into wall outlet.

13.Slide the upper decorative flue section into the lower decorative flue section.

NOTE

For non-ducted applications, the upper flue should be oriented so the louvers are towards the ceiling.

14.Carefully place the upper/lower flue assembly into the recessed area of the hood.

15.Slide the upper flue upward until it is aligned with the non- duct plenum. The non-duct plenum should be inside the flue. Secure the upper flue to the non-duct plenum using (2) 4mm x 12mm mounting screws.

NOTE

9-10 ft. ceilings may require Flue Extension Model FXNE58SS depending on installation height (purchase separately). Discard the upper and lower flues supplied with your hood and replace them with Flue Extension Model FXNE58SS.