MODELS EW5830SS • EW5836SS
CLEANING & MAINTENANCE
For performance, appearance, and health reasons, clean filter, fan and
Clean
Clean the
The motor is permanently lubricated and never needs oiling. If the motor bearings make excessive or unusual noise, replace the blower assembly with an exact service replacement.
LIGHT BULBS
| SUCTION |
| CUP TOOL |
HALOGEN | (1) |
PUSH IN | |
BULB |
|
(2) |
|
ROTATE |
|
CLOCKWISE |
|
WARNING
Bulbs may be hot. Always allow bulbs to cool down before removing them.
Use (2) Halogen Bulbs (included with hood) - 120 V, 35 W, shielded halogen bulbs - MR16 with GU10 base.
NOTE
Suction Cup Tool (included with hood) can be used to install and remove light bulbs. Align pins on bulb with large diameter opening on socket, then push bulb in towards hood and rotate clockwise until firmly seated. The position of the bulb socket (depth) is adjustable and may require adjustment when: a) certain brands of bulbs are difficult to install. b) the bulb protrudes too far below the light panel.
Page 8
LAMP SOCKET
BRACKET
LIGHT | SCREWS |
PANEL |
To change the depth of bulb sockets:
-Remove 2 screws on light panel – set screws aside
-Remove Light Panel.
-Loosen 2 Screws holding Lamp Socket Bracket to Light Panel.
-Adjust socket/bracket to desired depth.
-
-