Broan QP330SS Install The Hood, Connect The Wiring, Install Light Bulbs, QP336BL QP336SS QP336WW

	MODELS QP330BL • QP330SS • QP330WW
		QP336BL • QP336SS • QP336WW
		QP342BL • QP342SS • QP342WW
		Page 7
INSTALL THE HOOD		CONNECT THE WIRING

WARNING

To reduce the risk of electrical shock, switch power off at service panel. Lock or tag service panel to prevent

power from being switched on accidentally.

ELECTRICAL

WIRING BOX

COVER

ELECTRICAL

POWER

CABLE

KNOCKOUT

14Remove Electrical Wiring Box Cover from inside

of hood and appropriate Electrical Power Cable Knockout from top or back of hood.

HOUSE

POWER CABLE

15 Run House Power Cable between service panel and hood location. Attach power cable to hood using appropriate clamp.

16 Hang hood from (4) mounting screws driven part-way into cabinet locations (shown in illustrations under “PREPARE HOOD LOCATION”). Mounting screws are included in parts bag. Slide hood back towards wall until mounting screw heads are engaged in narrow end of keyhole slots in top of hood. Tighten screws securely. Add 5th mounting screw in center hole in hood and tighten securely.

17DUCTED INSTALLATION ONLY:

Connect ductwork to hood and use duct tape to make joints secure and air-tight. Make sure the damper / duct connector enters the ductwork and that the damper opens and closes freely.

GROUND

SCREW

HOUSE

POWER CABLE

18 Connect House Power Cable to range hood wiring - BLACK to BLACK, WHITE to WHITE, and GREEN or

BARE WIRE to Ground Screw. Replace electrical wiring box cover.

19 Re-attach Bottom Pan with 6 Screws removed in Step 6.

INSTALL LIGHT BULBS

	SUCTION
	CUP TOOL
HALOGEN	(1)
	PUSH IN
BULB
(2)
ROTATE
CLOCKWISE
LIGHT PANEL
SCREWS	LIGHT PANEL

CAUTION: Bulbs may be hot. Refer to bulb packaging for further information.

20 Install (4) Halogen Bulbs (included with hood). Use 120 V, 50 W, shielded halogen bulbs - MR16 with GU10 base.

NOTE: Suction Cup Tool (included with hood) can be used to install and remove light bulbs.

Align pins on bulb with large diameter opening on socket, then push bulb in towards hood and rotate clockwise until firmly seated.

The position of the bulb socket (depth) is adjustable and may require adjustment when:

a)certain brands of bulbs are difficult to install.

b)the bulb protrudes too far below the light panel.