Field
PAE Capability
system-auth-control
re-authentication
TABLE 32

Displaying 802.1X information

none – Use no authentication. The client is automatically authenticated without the device using information supplied by the client.

NOTE

If you specify both radius and none, make sure radius comes before none.

Displaying 802.1X information

You can display the following 802.1X-related information:

The 802.1X configuration on the device and on individual ports

Statistics about the EAPOL frames passing through the device

802.1X-enabled ports dynamically assigned to a VLAN

User-defined and dynamically applied MAC address filters and IP ACLs currently active on the device

The 802.1X multiple-host configuration

Displaying 802.1X configuration information

To display information about the 802.1X configuration on the Brocade device, enter the show dot1x command.

Brocade# show dot1x

PAE Capability: Authenticator Only

system-auth-control: Enable

re-authentication: Disable

global-filter-strict-security: Enable

quiet-period: 60 Seconds

tx-period: 30 Seconds

supptimeout: 30 Seconds

servertimeout: 30 Seconds

maxreq: 2

re-authperiod: 3600 Seconds

Protocol Version: 1

Syntax: show dot1x

The following table describes the information displayed by the show dot1x command.

Output from the show dot1x command

Description

The Port Access Entity (PAE) role for the Brocade device. This is always “Authenticator Only”.

Whether system authentication control is enabled on the device. The dot1x-enablecommand enables system authentication control on the device.

Whether periodic re-authentication is enabled on the device. Refer to “Configuring periodic re-authentication”on page 175.

When periodic re-authentication is enabled, the device automatically re-authenticates Clients every 3,600 seconds by default.

184

Brocade ICX 6650 Security Configuration Guide

 

53-1002601-01

Page 204
Image 204
Brocade Communications Systems 6650 manual Displaying 802.1X information, Displaying 802.1X configuration information