Wound evenly Wound poorly | Brother 885-S25/S27 guide

4While holding the end of the thread, gently press the foot controller to wind the thread around the bobbin a few times. Then stop the machine.

5Trim the excess thread above the bobbin.

6Press the foot controller to start.

7When the bobbin seems full and begins spinning slowly, take your foot off the foot controller.

8Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.

Note

●The needle bar does not move when you slide the bobbin winder shaft to the right.

●Immediately after winding the bobbin, it is normal to hear the sound of the clutch engaging when beginning to sew or turning the handwheel.

CAUTION

●Make sure you follow the instructions carefully. If you do not cut the excess thread completely before winding the bobbin, when the thread runs low it may tangle around the bobbin and cause the needle to break.

CAUTION

●Not winding the bobbin properly may cause the thread tension to loosen, and may break the needle.

12

1Wound evenly

2 Wound poorly

1

17

Image 19

Brother 885-S25/S27 operation manual Wound evenly Wound poorly

Contents

Appendix Important Safety Instructions For Users in the UK, EIRE, Malta and Cyprus only Please Read These Instructions Before YOU USE the Machine UNPACKING/REPACKING Instructions Contents Appendix Main Parts Knowing Your Sewing Machine Optional Accessories Accessories Connecting Plugs Using Your Sewing Machine Replacing the Needle Main Power and Sewing Light SwitchFoot Controller Checking the Needle Touches the stopper, and securely tighten Changing the Presser Foot 1Slide the flat bed attachment to the left to release it Using a Free-arm StyleFlat Bed Attachment 1Slideopen theit. flat bed attachment to the left to Pattern Selection Dial ControlsStitches Manual Patterns and Stitch NamesPattern Recommended Instruction Width 3/16 Fixed 3/32 Stitch Length Dial Stitches Selecting a Stretch Stitch Stretch StitchingStitch Width Dial Reverse Sewing Lever Winding the Bobbin Threading the Machine Wound evenly Wound poorly Lower Threading Lower Threading for models equipped with a quick-set bobbin Follow steps 1 and 2 from Lower Threading Upper Threading Raise the presser foot using the presser foot lever 6Putneedle.the thread behind the guide above Hook Thread Sewing with a Twin Needle Drawing up the Lower Thread Thread Tension Medium FABRIC, THREAD, and Needle CombinationsFabric Type Thread Size of Needle Size Fixed 16-0 Please Read Before SewingStraight Stitching Pattern Zigzag Stitch Zigzag StitchingStitch Stitch Name Zigzag Stitch 3/16 Blind Hem StitchingShell Tuck Stitching Stitch 4Sew at a slow speed Elastic StitchingElastic Stitch Stitch Double Action StitchingPatchworking Overedge Stitching Triple Zigzag Stretch Stitching Feather StitchingFixed 3/16 Decorative Stitching Stitch Pattern Making a ButtonholePattern Adjusting Buttonholes Other Sewing Buttons Zipper Insertion Using Attachments and Applications Stitch Any GatheringDarning Foot Zigzag Stitch Any AppliquésMonogramming Embroidering Stitch Width Keep fingers away from moving parts, especially needles Using the Walking Foot Optional Accessories Stitch Plate Using the Quilting Foot 16-3/32 Using the 1/4-inch Quilting FootQuickly Stitch Together a Quilt Put the light cover back on and fasten the screw MaintenanceCleaning Changing the Light Bulb 0Install the needle plate cover Symptom Possible cause How to put it right Reference Troubleshooting Fabric is LowerOr breaks Thread ten Pitched noise While sewing Stitches areSkipped There is a high Numerics Index English