Brother 885-S25/S27 Appliqués, Monogramming Embroidering, Stitch Width, Zigzag Stitch Any

Set the pattern selection dial to Zigzag Stitch.

Appliqués

Stitch Name	Pattern	Stitch Length	Stitch Width
		[mm (inch)]	[mm (inch)]
Zigzag Stitch		F-2	Any
		(1/64-1/16)

You can create an applique by cutting a different piece of fabric into a shape and using it as a decoration.

1Baste the cut design to the fabric.

2Carefully sew around the edge of the design with a zigzag stitch.

3Cutstitching.away any fabric that is left outside the

4Remove the basting, if necessary.

Memo

●Make reinforcing straight stitches at the beginning and the end of the zigzag stitching.

CAUTION

●Be careful that the needle does not hit a pin during sewing. The needle could break, and you may be injured.

Monogramming and

Embroidering

		Stitch	Stitch
Stitch	Pattern	Length	Width	Foot	Other
Name		[mm	[mm
		(inch)]	(inch)]
Zigzag		Any	Any	None	Darning
Stitch					Plate

■Preparing for Monogramming and Embroidering

1Remove the power supply plug from the outlet. Place the darning plate on the needle plate, and reconnect the power supply plug to the wall outlet.

25

3Draw the lettering (for monogramming) or design (for embroidering) on the surface of the fabric.

4Stretch the fabric between embroidery hoops as firmly as possible, with the underside of the fabric on the bottom of the inside hoop.

5Put the work under the needle and lower the presser bar with the foot removed.

6Pull the lower thread up through the starting position by turning the handwheel and make a few holding stitches.

39