USING ATTACHMENTS AND APPLICATIONS
CAUTION
●Use a screwdriver to tighten the screw securely. If the screw is loose, the needle may hit the presser foot and you may be injured.
●Before you start sewing, make sure you turn the handwheel toward you (counterclockwise) to check that the needle does not hit the presser foot.
●Be careful not to touch the needle, otherwise you may be injured.
Note
●When sewing with the walking foot, sew at medium to low speeds.
Using the Quilting Foot
Stitch |
|
| Stitch | Stitch |
| |
Pattern | Length | Width | Other | |||
Name | ||||||
|
| [mm (inch)] | [mm (inch)] |
| ||
|
|
|
| |||
|
|
|
|
|
| |
Straight |
|
| Any | 2.5 | Darning | |
|
| |||||
Stitch |
|
| (3/32) | Plate | ||
|
|
| ||||
|
|
|
|
|
| |
|
|
|
|
|
| |
The Quilting Foot is useful for darning and
1Removeoutlet. the power supply plug from the
2Raise the needle and the presser foot.
3Loosen the presser foot screw to remove the presser foot holder.
2
13
1Screwdriver
2Presser foot holder
3 Presser foot screw
4Attach the quilting foot, making sure that part A shown in the illustration is above the needle clamp screw. Then lower the presser foot lever and tighten the presser foot screw.
•Make sure that the needle clamp screw is firmly tightened.
A
1 
2
1Presser foot screw
2 Needle clamp screw
CAUTION
●Be careful not to touch the needle, otherwise you may be injured.
●Use a screwdriver to tighten the presser foot holder screw securely. If the screw is loose, the needle may hit the presser foot and you may be injured.
●Before you start sewing, make sure you turn the handwheel toward you (counterclockwise) to check that the needle does not hit the presser foot.
5Put the darning plate on the needle plate.
Connect the power supply plug to the wall outlet.
6SetStitch.the pattern selection dial to the Straight
•Before starting to sew, draw the quilting design on the fabric.
42
