Brother FAX-8070P MEDIA TYPE ERROR MANUAL FEED , SIZE ERROR XXX , NO TRAY ID XXX SIZE ERROR DX , SIZE ERROR MX , NO DX UNIT DX LEVER ERROR NO MX UNIT DIMM ERROR , CARD ERROR , HDD ERROR , CARD REMOVAL , LINE ERROR , BUFFER ERROR STORAGE FULL

6–2
E
E
Er
r
rr
r
ro
o
or
r
r M
M
Me
e
es
s
ss
s
sa
a
ag
g
ge
e
eA
A
Ac
c
ct
t
ti
i
io
o
on
n
n
MEDIA TYPE ERROR Specify the correct media type: XX.
MANUAL FEED The size of paper in the multi-purpose tray is wrong. Load the correct
size of paper in the multi-purpose tray, or while the printer is in Stop
mode, and then press the Go switch.
SIZE ERROR XXX Set the correct paper that you want to use into the indicated tray, or
load the same size paper that you selected in the current driver
setting. “What kind of paper can I use?” in Chapter 1.
NO TRAY ID XXX Install the specified ID tray.
SIZE ERROR DX Set the correct paper that you want to use, or load the same size
paper that you selected in the current driver setting. See “What kind of
paper can I use?” in Chapter 1.
SIZE ERROR MX Set the correct paper that you want to use, or load the same size
paper that you selected in the current driver setting. See “What kind of
paper can I use?” in Chapter 1.
NO DX UNIT Install the duplex unit correctly. See the duplex unit U ser’s Gu ide.
DX LEVER ERROR Set the duplex lever to the correct position.
NO MX UNIT Change the job properties or install the Mailbox unit correctly.
DIMM ERROR Install the DIMM correctly.
Turn off the printer. Wait a few seconds, and then turn it on again. I f
this error message appears again, replace it with a new card.
CARD ERROR Make sure of the following points:
•The cable is connected correctly.
•The card is installed correctly.
•The installed card is formatted correctly.
Turn off the printer. Wait a few seconds, and then turn it on again. I f
this error message appears again, replace it with a new card.
HDD ERROR Make sure of the following points:
•The cable is connected correctly.
•The HDD is installed correctly.
•The installed HDD is formatted correctly.
Turn off the printer. Wait a few seconds, and then turn it on again. I f
this error message appears again, replace it with a new HDD.
CARD REMOVAL Turn off the printer. Wait a few seconds, and then turn it on again. If
this error message appears again, replace it with a new CompactFlash
card.
LINE ERROR Check the Serial interface settings. (baud rate, code type, parity and
hand shake protocols).
BUFFER ERROR Check the Interface settings.
STORAGE FULL Delete unnecessary macros o r fonts, or use a new card or HDD.