4 - 5
INITIAL SETUP
WARNING
It is important that you do not choose PERMANENT unless all users are
hearing-impaired. Otherwise, the default setting of AMPLIFY may damage the
hearing of some users.
Setting Volume Amplify
Please carefully read Setting the Handset Volume before you do the following steps:
1
Press Menu/Set, 1, 4.
2
Press to select VOL AMPLIFY:OFF? if
none of the users are hearing-impaired and go to
Step 4ORIf some or all of the users are hearing-
impaired, select VOL AMPLIFY:ON? and then press Menu/Set.
3
Press to select PERMANENT? if all the users
are hearing-impairedORSelect
TEMPORARY? if only some of the users are
hearing-impaired.
4
Press Menu/Set.
5
Press Stop/Exit.
Setting the Ring Volume
You can adjust the ring volume when your fax machine is idle. You can select a ring
volume level or press until the ring is off.
Press to adjust the volume level. With each key press, the fax machine rings so
you can hear the current setting and the LCD shows the setting you are choosing. Each
key press changes the volume to the next setting. The new setting will remain until you
change it again.
Setting Beeper Volume
You can set the beeper to LOW, HIGH or OFF. The default setting is LOW. When
the beeper is set to LOW or HIGH, the fax machine beeps every time you press a key
or make an error, and at the end of fax sending or receiving.
1
Press Menu/Set, 1, 3.
2
Press to select your setting, and then press Menu/Set.
3
Press Stop/Exit.

4.VOLUME AMPLIFY

VOL AMPLIFY:OFF?

or

PERMANENT?

or
or

3.BEEPER

or