9 - 11
MESSAGE CENTER
Retrieving Memory Status List
You can retrieve the Memory Status List from a remote fax machine to see if you have
any fax messages.
1
Dial your fax number.
2
When you hear the beep, immediately enter your Remote Retrieval Access Code
(1 5 9 ).
3
When you hear two short beeps, use the dial pad to press 9 6 1.
4
Using the dial pad, enter the number of the remote fax machine (up to 20 digits) where
you want the Memory Status List forwarded followed by # #.
5
After you hear your fax machine beep, hang up and wait.
Your fax machine calls the remote fax machine. The remote fax machine prints the
Memory Status List.
96 Retrieve a Fax
1 Memory Status List Enter the number of a remote fax machine to
receive a report or stored fax messages. (See
page 9-11.)
2 Retrieve all faxes
3 Erase fax in the memory If you hear one long beep, you can erase the fax
message from the memory.
97 Check the Receiving Status You can check whether your fax machine has
received any FAX or VOICE messages. If yes,
you will hear one long beep. If no, you will
hear three short beeps.
1 FAX
2 VOICE
98 Change Answer Mode If you hear one long beep, you can change the
answer mode. If you hear three short beeps,
you cannot change it. (Example: There is no
MSG CTR OGM when you want to change to
MSG CTR mode.)
1 MSG CTR
2 FAX/TEL
3 FAX ONLY
90 Exit After a long beep, you can exit Remote
Retrieval.
You can not use or # as dial numbers. However, if you want to store a pause,
press #.
Remote Commands Operation Details