OPTIONS 4 - 2
Lower tray unit (LT-27CL)The lower tray unit (Tray 2) is an optional device that can hold up to 530 sheets of extra paper (75 g/m2
or 20 lb). You can put Letter, A4, B5 (JIS and ISO) or Executive size (176x250 to 215.9x297mm) paper
in this tray. If you want to buy the optional lower tray unit, call the dealer you bought the printer from.
Putting paper in the lower tray unit
After you have installed the lower paper tray, you can put paper in it the same way you put paper in the
upper paper tray.
How to install the lower tray unit
Caution
When moving or lifting this printer, keep the printer flat. To avoid spills, you must first remove the
toner cartridges and waste toner pack.
1
Turn off the printer power switch and unplug the printer.
2
Place the lower tray unit on a flat table, and then remove the protective parts.
Figure 4-1
■This printer is heavy and weighs approximately 31.5 kg (69.4 lb). To prevent injuries, use at
least two people to lift the printer.
■When you lift the printer make sure you use the handholds at the bottom four corners of the
printer.
■When placing the printer on top of the lower tray unit, be careful not to catch your fingers
between them.
■Do not carry the printer when the lower tray unit and/or the duplex unit are attached.