Brother NX 400 manual 2Turn off the sewing machine 3Raise the presser foot lever

CAUTION

●Be sure to securely tighten the screw with the screwdriver, otherwise the needle may touch the presser foot, causing it to bend or break.

●Before starting to sew, slowly turn the balance wheel toward you and check that the needle does not touch the presser foot. If the needle hits the presser foot, the needle may bend or break.

Note

●When sewing with the walking foot, sew at a speed between slow and medium.

■Removing the walking foot

1Press (needle position button) once or twice to raise the needle.

1

1Needle position button

XThe needle is raised.

2Turn off the sewing machine.

3Raise the presser foot lever.

1

1Presser foot lever

XThe presser foot is raised.

4With a screwdriver, loosen the presser foot holder screw, and then remove the walking foot.

5Attach the presser foot holder.

•For details, refer to “Removing the presser foot holder” (page 39).

Memo

●Only the straight stitch (with reinforcement stitching) and the zigzag stitch can be used with the walking foot. For details on the stitches, refer to “Stitch Settings” (page 128).

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

Replacing the Presser Foot 41