Brother NX 400 manual Changing the stitch density, Changing the pattern length

UTILITY STITCHES ——————————————————————————————————————————————————

Changing the stitch density

If a decorative satin stitch has been selected, the stitch density can be changed.

1Select a decorative satin stitch .

2Press (settings key) in the operation panel.

X The settings screen appears.

3Press , , and (arrow keys) until

is selected.

4Press (OK key).

XThe screen for specifying the stitching density of the decorative satin stitch appears.

5Pressselected. and until the desired density is

Select for coarser stitching or select for finer stitching.

6Press (OK key).

XThe initial stitch screen appears again, and the stitching density is changed.

CAUTION

●If the stitching density is too fine, depending on the needle, the stitches may be bunched together, causing the needle to break.

Changing the pattern length

The length of one part of a satin stitch can be set to one of five sizes.

1Select a satin stitch .

2Press (settings key) in the operation panel.

X The settings screen appears.

3Press , , and (arrow keys) until

is selected.

4Press (OK key).

XThe screen for changing the length of a satin stitch appears.

5Pressselected. and until the desired ratio is

The length can be set within the range of

and .

XThe satin stitch length is changed.

6Press (OK key).

XThe initial stitch screen appears again.

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

118