Brother NX 400 manual Eyelet Stitching, Attach monogramming foot N

UTILITY STITCHES ——————————————————————————————————————————————————

Eyelet Stitching

Eyelets, such as those on belts, can be sewn. Three sizes of eyelets are possible: 7 mm, 6 mm and 5 mm (1/4, 15/64 and 3/16 inch).

			Stitch Width		Stitch Length		Presser
Stitch Name	Pattern	Application	[mm (inch.)]		[mm (inch.)]
							Foot
			Auto	Manual	Auto	Manual
	56			7.0, 6.0 or		7.0, 6.0 or
Eyelet stitch		Sewing eyelets, for example,	7.0	5.0 (1/4,	7.0	5.0 (1/4,	N
		on belts	(1/4)	15/64 or	(1/4)	15/64 or
				3/16)		3/16)

CONTENTS GETTING

1Attach monogramming foot “N”.

•For details, refer to “Replacing the presser foot” (page 37).

2Select stitch 56 .

•For details, refer to “Selecting stitching” (page 68).

3Adjust either the stitch width or the stitch length to select the desired eyelet size.

7 mm 6 mm 5 mm (1/4 inch)(15/64 inch) (3/16 inch)

•For details, refer to “Adjusting the Stitch Width and Length” (page 55).

4Lower the needle into the fabric at the beginning of the stitching, and then lower the presser foot lever.

5Start sewing.

X Once sewing is completed, the machine automatically sews reinforcement stitches, then stops

6Use the eyelet punch to cut a hole in the center of the eyelet.

•When using the eyelet punch, place thick paper or some other protective sheet under the fabric before punching the hole in the fabric.

Memo

●If thin thread is used, the stitching may be coarse. If this occurs, sew the eyelet twice, one on top of the other.

READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

104