Brother NX 400 manual Installing the bobbin, Slide the bobbin cover latch to the right

Remove the bobbin cover.

GETTING READY ———————————————————————————————————————————————————

Installing the bobbin

Install the bobbin wound with thread.

CAUTION

●Use a bobbin thread that has been correctly wound, otherwise the needle may break or the thread tension will be incorrect.

●The bobbin was designed specifically for this sewing machine. If bobbins from older models are used, the machine will not operate correctly. Use only the enclosed bobbin or bobbins of the same type (part code: SA156, XA5539-151).

Actual size

11.5mm (7/16 inch)

This model Older model

Memo

●The order that the bobbin thread should be passed through the shuttle is indicated by marks around the shuttle. Be sure to thread the machine as indicated.

1Slide the bobbin cover latch to the right.

1 2

1Bobbin cover

2 Latch

XThe bobbin cover opens.

2

3Hold the bobbin with your right hand and hold the end of the thread with your left.

• Be careful not to drop the bobbin.

4Insert the bobbin into the shuttle so that the thread unrolls to the left.

• Be sure to insert the bobbin correctly.

5Lightly hold down the bobbin with your right hand, and then guide the thread as shown with your left hand.

6Pass the thread through the slot as shown, and then pull the thread out toward the front.

1

1Cutter

XThe cutter cuts the thread.

CONTENTS GETTING READY SEWING BASICS UTILITY STITCHES APPENDIX

INDEX

22