Changing Needles and Light Bulb
Note
Please make sure power is off before carrying out the following operations. There is a chance of injury if the machine accidentally starts running during this operation.
Changing the Feed Pin
1Set the feed dogs to "velvet"
position. (see Page 5)
2Remove needle, presser
foot and needle plate.
Note
Please make sure power is off before carrying out the following operation. The glass plate over the light bulb will be hot immediately after using the machine, so you should wait until the machine has had a chance to cool down before changing bulbs.
CONTENTS |
Accessories |
Changing the Needle
1Turn the sewing machine off. Raise needle to highest position using hand wheel, and lower presser foot.
2Loosen screw with screw- driver, and remove needle.
3Insert new needle, and tighten screw. Make sure needle is screwed in tightly.
✽Check needles on a flat surface to make sure they're not bent.
Screwdriver
The needle should lay parallel to a surface.
flat surface
Lay needle on a flat surface
(such as the needle plate or a plate
of glass).
3Lower presser foot and turn hand wheel until feed
pin is in its highest position.
4Insert small screwdriver (included) as shown in diagram.
5While holding spring with fingertip, lower the feed pin changer onto the needle to pick it up.
6Attach new feed pin to feed pin changer, lower and attach while holding spring with fingertip.
7Remove screwdriver.
8Re-attach needle plate, needle and presser foot.
Changing Light Bulbs
1Turn off power.
2 Remove screws from Screwdriver head.
3Remove head.
4Unscrew bulb and remove.
5 Screw in new bulb. Rated 120V 15W
6
Light
Parts | Names |
| of |
Begin | Before You |
Light Bulb | Needles and | Changing | |
| Threading |
| |
Needle Chart | Samples and | Stitch | |
Presser Feet | Changing | ||
Sewing | Basic | ||
Machine | Your | Caring for | |
Note
HLX5 needles should be uses; however, Schmetz 130/705H may also be used under normal
610 circumstances.
Bulb
Shooting | Trouble |
