|
|
| Bobbin Stop |
6 While holding the end of the thread, | 7 Stop winding when bobbin is full. | 8 Manually move bobbin stop back to 9 Cut thread and remove bobbin. | |
step on the foot controller for a few | Take foot of foot controller. | original position. | |
seconds. Once enough thread has |
|
| |
wound itself around the bobbin to hold |
|
| |
itself in place, release the foot |
|
| |
controller and trim the excess thread. |
|
| |
Bobbin Insertion | CAUTION – Moving parts – |
| |
To reduce risk of injury, switch off before servicing. Replace cover. | |||
|
| Latch Spring |
|
Slide Plate |
|
|
|
| Thread Notch | |
Bobbin Door | ✽ Bobbin should be | |
positioned so it | ||
| ||
| winds to the left |
CONTENTS | |
Accessories | |
Parts | Names |
| of |
Begin | Before You |
Light Bulb | Needles and | Changing | |
| Threading |
| |
Needle Chart | Samples and | Stitch | |
Presser Feet | Changing | ||
Sewing | Basic | ||
Machine | Your | Caring for | |
1Lift slide plate (and open bobbin door).
812
2Put bobbin into the bobbin case.
✽Run thread through thread notch and under latch spring, so that a length of about 10 centimeters is exposed.
3Pull the latch lever of the bobbin case out and push the bobbin case into the shuttle race and release the latch lever.
✽If the latch lever is not all the way on the hook, it may fly off during sewing and cause lower thread breakage.
4Lower slide plate and close bobbin door.
Shooting | Trouble |
