Brother QL-1050N manual Connecting the Power Supply

3 Thread the end of the DK Roll into the slot until it can be seen from the other side.

When unable to thread the end of the DK Roll into the slot, thread it as far as possible, and then close the cover.

Press the ON/OFF button to turn the QL-1060N on, and then press the FEED button to set the roll.

4 Close the DK Roll compartment cover until it clicks right and left side.

4 Connecting the Power Supply

Connect the power cord to the QL-1060N and then plug the power cord into a electrical outlet.

• Check that the electrical outlet is 120V AC before plugging the power cord.

• Unplug the power cord from the electrical outlet after you have finished using the QL-1060N.

• Do not pull the power cord when unplugging it from the electrical outlet. The wire in the power cord may become damaged.

•Do not connect the QL-1060N to the computer until directed to do so when installing the printer driver.

9

Introduction

STEP

1

Getting started

STEP

2

Software	WindowsFor
	®
the	®
Installing	For Macintosh

STEP

3

Label Overview

STEP

4

Reference