3
Control panel setup
LAN menu
The control panel LAN menu section can be used to configure network settings.
Press Menu, 5 for LAN and then proceed to the menu selection you wish to configure. | 3 |
|
Please note that the machine is supplied with the BRAdmin Professional Windows® software, BRAdmin Light
Macintosh® software and RemoteSetup which also can be used to configure network settings (See the Network User’s Guide located on the
Note
If you already installed your machine for a network connection following the steps in the Quick Setup Guide then the TCP/IP settings have already been configured. You should only need to configure the Internet Fax settings. Go to Setup Internet on page 19.
Setup TCP/IP
This menu has nine sections: Boot Method, IP Address, Subnet Mask, Gateway, Node Name, WINS Config, WINS Server, DNS Server and APIPA.
BOOT Method
This selection controls how the machine obtains the IP address for itself. The default setting is Auto.
a b c d
Press Menu, 5, 1, 1.
Press a or b to select Auto, Static, RARP, BOOTP or DHCP.
Press OK.
Press Stop/Exit.
Auto mode
In this mode, the machine will scan the network for a DHCP server, if it can find one, and if the DHCP server is configured to allocate an IP address to the machine, then the IP address supplied by the DHCP server will be used. If no DHCP server is available, then the machine will scan for a BOOTP server. If a BOOTP server is available, and it is configured correctly, the machine will take its IP address from the BOOTP server. If a BOOTP server is not available, the machine will scan for a RARP server. If a RARP server also does not answer, the IP Address is scanned through the APIPA facility. After it is initially powered ON, it may take a few minutes for the machine to scan the network for a server.
13
