Instructions for removing Door Leaf with Spring | 1248 Spring Hinge |
Loaded Hinges (See Figure #15) |
|
1.Open Door to dwell position, stopping at approx. 120˚.
2.Put mark on floor to indicate position of Door.
See sketch. | Figure #15 |
|
3.Lift Door off frame.
4.To replace Door, line up Door with mark on the floor.
5. Place Hex Hole in hinge straps over Hex Rods and | 120˚ |
lower Door. | Strap |
| Door |
| Mark |
| 45˚ Approx. |
Instructions for Door Hinge Pin replacement, | |
(See Figure #16) |
|
| Rotate Pin until it is in this |
| |
10˚ Approx. | approximate position. |
|
Figure #16
Top View
Back of Strap View
*For Offset Hinge, Pin is rotated 180 Degrees
Adjusting Door Closer (See Figure #17)
For proper operation with roller in down position, adjust hook to 1/32" above roller.
Jamb
Hook
Lip
Lever
Roller
Door
1/32” Clearance
Figure #17
Warning!
Door Closure lever must remain horizontal when door is open.
17
