Installation of floor panels secured for seismic and wind - exterior applications
After the floor is installed per the instructions above, obtain the hardware and tools for the application of “Tapcon” anchors.
1.1/4" “Tapcon” Phillips flat head anchors or equal
2.“Tapcon” drill bit; 3/16" x 6 1/2" (No.
Drill through the female cam lock located in the floor panel into the concrete pad to a depth of 2" or more to insure the anchor does not bottom out. (If leveling shims are required, locate shims close to the location of the anchors) Space holes around the perimeter of the floor system at each cam lock location (eliminate anchors when space is less than 15" from previous anchor) spaced no further than 24". Insert and tighten the “Tapcon” anchors into each hole. DO NOT OVER TIGHTEN. Recheck floor for level and square prior to installation of walls.
PVC Panel Track Installation for Floorless Walk-In
Warning! When W. A. Brown does not provide the insulated floor, check carefully before installing the
PVC Panel Track Layout (Required where no insulated floor is ordered from Brown)
1.Mark the exact area the
2.Field cut 12' pieces of the PVC panel track to size for your particular
3.Mark and cut door opening location.
4.Fasten track to the floor using ramset studs, screws or other fasteners (not supplied by WAB.) (See Figure #5)
5.Determine where shims are needed for leveling, cut them so they will fit in the channel of the track. The wall panels are leveled during the installation process.
6.Seal all open areas around the track using silicone sealant (not provided by WAB.)
7.The wall panels do not lock to the track in this application.
Figure #4 | Figure #5 |
4
