Bryant 44760 Mount Wallplate and Thermostat, Connect Wires and Mount Thermostat to Wallplate, G C L O W2 B E R Y1

41652_model44760_web.pmd

14

INSTALLATION 14

Mount Wallplate and Thermostat

■Remove the wallplate from your thermostat by pressing the release tab on the bottom of the thermostat. (See Figure 2.)

■Position wallplate on wall and pull existing wires through large opening. Then level for appearance. Mark holes for plas- tic anchors provided if your existing holes do not line up with those on the Hunter wallplate.

Figure 2

■Drill holes with 3/16" bit and gently tap anchors into the holes until flush with wall.

■Reposition wallplate to wall, pulling wires through large opening. Insert mounting screws provided into wall anchor and tighten. (See Figure 3.)

C

O

F

		W2	G
	Y1
R

Figure 3

15

Connect Wires and Mount Thermostat to Wallplate 15

■Straighten bare end of each wire and cut or strip it to 1/4” maximum. Insert each labeled wire into the bottom of the maching terminal. Refer to figures 4 and 5.

■Hold the wires in each terminal and tighten the terminal screws securely, otherwise a loose wire could cause opera- tional problems with your system or thermostat.

■Push excess wire back into hole to prevent interference with mounting of the thermostat.

■Make sure the Power Switch is set to OFF.

■Insert two AAA size alkaline batteries, observing the polarity marked on the unit.

■Insert the upper tabs on the thermostat body into the slot at the top of the wallplate. Press bottom of the thermostat body to snap it into the wallplate. (NOTE: Do not force the ther- mostat onto the wallplate, as the terminal pins may be damaged. If it does not snap properly, the thermostat may not work.)

■Switch on the main power at the panel or furnace.

R Y1

Figure 4

Insert

R

G C L O W2 B E R Y1

G C L O W2 B E R Y1

Figure 5