Bryant 548J*14D Field Connections, Outdoor Air Temperature OAT Sensor, EconoMi$er2

548J*14D

Outdoor Air Temperature (OAT) Sensor —

The OAT is factory-mounted in the EconoMi$er2 (FIOP or accessory). It is a nominal 10k ohm thermistor attached to an eyelet mounting ring.

EconoMi$er2 —

The RTU-MP control is used with EconoMi$er2 (option or accessory) for outdoor air management. The damper position is controlled directly by the RTU-MP control; EconoMi$er2 has no internal logic device.

Outdoor air management functions can be enhanced with field-installation of these accessory control devices:

Enthalpy control (outdoor air or differential sensors) Space CO2 sensor

Outdoor air CO2 sensor

Field Connections

Field connections for accessory sensors and input devices are made the RTU-MP, at plugs J1, J2, J4, J5, J11 and J20. All field control wiring that connects to the RTU-MP must be routed as shown in Fig. 28. This routing provides the UL required clearance between high- and low-voltage wiring. Connect to the wires to the removable Phoenix connectors and then reconnect the connectors to the board.

Space Temperature (SPT) Sensors —

Afield-supplied Bryant space temperature sensor is required with the RTU-MP to monitor space temperature. There are 3 sensors available for this application:

S 33ZCT55SPT, space temperature sensor with override button

S 33ZCT56SPT, space temperature sensor with override button and setpoint adjustment

S 33ZCT59SPT, space temperature sensor with LCD (liquid crystal display) screen, override button, and setpoint adjustment

Use 20 gauge wire to connect the sensor to the controller. The wire is suitable for distances of up to 500 ft. Use a three-conductor shielded cable for the sensor and setpoint adjustment connections. If the setpoint adjustment (slidebar) is not required, then an unshielded, 18 or 20 gauge, two-conductor, twisted pair cable may be used.

Connect T-55:See Fig. 37 for typical T-55 internal connections. Connect the T-55 SEN terminals to RTU-MP J20-1 and J20-2. See Fig. 38.

1	2	3	4	5	6	RED(+)
					WHT(GND)		CCN COM
						BLK(-)
			SEN
	SW1
					BRN (GND)		SENSOR WIRING
					BLU (SPT)

C08201

Fig. 37 - T-55 Space Temperature Sensor Wiring

SEN J20-1

SEN J20-2

C08460

Fig. 38 - RTU-MP T-55 Sensor Connections

Connect T-56:See Fig. 39 for T-56 internal connections. Install a jumper between SEN and SET terminals as illustrated. Connect T-56 terminals to RTU-MP J20-1, J20-2 and J20-3 per Fig. 40.

1	2	3	4	5	6	RED(+)
					WHT(GND)		CCN COM
						BLK(-)
			SEN		SET
	SW1					BLK
						(T56)
					BRN (GND)		SENSOR WIRING
					BLU (SPT)
							JUMPER
							TERMINALS
							AS SHOWN

Cool Warm

C08202

Fig. 39 - T-56 Internal Connections

22