Bryant 548J*14D Economizer Wiring, Two Position Damper Hood Removal and Setup - Factory Option

Remove Hood Parts

Cut Plastic Ties

(2) Places

Economizer

C10005

Fig. 9 - Economizer Wiring

Two Position Damper Hood Removal and Setup - Factory Option —

1.The hood is shipped in knock-down form and assembled to a metal support tray using plastic stretch wrap. Located in the return air compartment, the assembly’s metal tray is attached to the basepan and also attached to the damper using two plastic tie-wraps.

2.To gain access to the hood, remove the filter access panel. (See Fig. 8.)

3.Locate the (2) screws holding the metal tray to the basepan and remove. In order to remove the screws, it may be necessary to remove the panel underneath the two-position damper. Remove the two screws. Locate and cut the (2) plastic tie-wraps securing the assembly to the damper. (See Fig. 10.) Be careful to not damage any wiring or cut tie-wraps securing any wiring.

4.Carefully lift the hood assembly (with metal tray) through the filter access opening and assemble per the steps outlined in Economizer Hood and Two–Position Hood on page 10.

5.If removed, reattach the panel under the damper.

548J*14D

Hood Parts

Plastic Tie Wrap

Qty (2)

Screws for Metal Tray

Qty (2)

C10006

Fig. 10 - Damper Assembly

9