Bryant 577D----A START-UP Checklist, Preliminary Information Model no, Temperatures, Pressures

577D-- -- A

START-UP CHECKLIST

(Remove and Store in Job Files)

I. PRELIMINARY INFORMATION MODEL NO.:

SERIAL NO.:

DATE:

TECHNICIAN:

II. PRESTART-UP (Insert check mark in box as each item is completed)

( ) VERIFY THAT ALL PACKING MATERIALS HAVE BEEN REMOVED FROM UNIT

( ) REMOVE ALL SHIPPING HOLD DOWN BOLTS AND BRACKETS PER INSTALLATION INSTRUCTIONS

( ) CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS

( ) CHECK GAS PIPING FOR LEAKS (WHERE APPLICABLE)

( ) CHECK THAT INDOOR (EVAPORATOR) AIR FILTER IS CLEAN AND IN PLACE

( ) VERIFY THAT UNIT INSTALLATION IS LEVEL

( ) CHECK FAN WHEEL, AND PROPELLER FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS

( ) MAKE SURE THAT - (If Applicable) ON A60 SIZE PURON HEAT PUMP ONLY, THE TWO WIRE TIRES FASTEN TO THE OUTDOOR COILS AND REVERSING VALVE/ACCUMULATOR HAVE BEEN REMOVED

III.START-UP ELECTRICAL SUPPLY VOLTAGE COMPRESSOR AMPS

INDOOR (EVAPORATOR) FAN AMPS

TEMPERATURES

OUTDOOR (CONDENSER) AIR TEMPERATURE							DB
RETURN-AIR TEMPERATURE						DB			WB
COOLING SUPPLY AIR		DB						WB
GAS HEAT SUPPLY AIR
PRESSURES
GAS INLET PRESSURE	IN. W.C.
GAS MANIFOLD PRESSURE				IN. W.C.
REFRIGERANT SUCTION			PSIG, SUCTION LINE TEMP*
REFRIGERANT DISCHARGE					PSIG, LIQUID TEMP{

( ) VERIFY REFRIGERANT CHARGE USING CHARGING CHARTS GAS HEAT TEMPERATURE RISE

TEMPERATURE RISE (See Literature) RANGE MEASURED TEMPERATURE RISE

( ) VERIFY THAT CONDENSATE CONNECTION IS INSTALLED PROPERLY

( ) VERIFY THAT OUTDOOR AIR THERMISTOR (OAT) IS PROPERLY INSTALLED & CONNECTED

* Measured at suction inlet to compressor

{Measured at liquid line leaving condenser.

E2010 Bryant Heating & Cooling Systems D 7310 W. Morris St. D Indianapolis, IN 46231	Edition Date: 04/10	Catalog No. II577D---06
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.		Replaces: II577D--- 05

40