BT 902 manual How to install the PowerGrid

How to install the PowerGrid 902

Comtrend’s PG902 starter kit, supplied in pairs, comes ready to use; the Powerline adapters are paired in our factory so they will recognize each other, which makes setup this easy:

1.Plug both PG902 adapters into an electrical socket

a.One next your router (or modem)

b.One next to the device you will connect to your network

2.The Status LEDs on both PG902 adapters will light up RED

3.When the Status LEDs are both GREEN the adapters are ready to use

Pick the PG902 adapter with a serial number ending with the letter “A”. The serial number can be found on the label at the back of the adapter. This is the Access Point (AP). Connect the AP to your router with an Ethernet cable, as shown here.

	/STB	Y
AP	HER	NET
ET
		US
STAT
		FIG
	CON ET
		RES
		ON
		STBY

PAodwaeprtleinrewEitthhFerilnteert

	On
Power				LAN	LINE
	Off	1X	2X	3X	4X

Connect the other PG902 to your computer, V-box or other network device using an Ethernet cable. This is the End Point (EP).

AP/S	TBY
ETHE	RNET
	US
STAT
	FIG
CON ET
RES
	ON
	STBY

260072-	021_PG902_User_Guide(UK_A5 5
		2008/8/6 �� 10:44:49