Buffalo Technology WLI-USB-L11G manual Cannot Edit Configuration Profile, Cannot Find the LAN card

B.2.4 Cannot Edit Configuration Profile

If you want to add/edit the Configuration Profile of your USB Client but the Client Manager icon is not visible, you may do the following:

•If the Client Manager is not running, select the Start button, Programs, MELCO wireless LAN and select Client Manager to start the Client Manager.

B.2.5 Cannot Find the LAN card

If the WLI-USB-L11G driver is installed into a PC more than once, the Client Manager will indicate, “cannot find the wireless LAN card.”

WLI-USB-L11G driver must be removed before re-installing it again. For re-installation refer to section 2.3 “Install Drivers.”

If Client Manager is older than the version 3.21, it is recommended to replace it with version 3.21 or later. To uninstall the Client Manager select Start - Program - MELCO Wireless LAN - Uninstall Client Manager .

B.2.6 It Takes a Long Time to Shutdown

Unplug the WLI-USB-L11G from the PC before turn off the PC

Me/98: After finishing browsing the Internet, disconnect the WLI-USB-L11G

B.2.7 WLI-USB-L11G Does Not Operate After Returning From the Stand-by or Sleeping Mode

This happened when the system is old and the host controller is causing this problem. If the PC is using NEC’s USB controller, our adapter may not work. WLI-USB-L11G should be unplugged and plug back in.

The following PCs will also have the same problem:

Toshiba Dynabook Satellite 2520 and Dynabook SS Protage3010CP

20