Bunn 40410.0000G service manual Cleaning Optional Large Sprayhead

Models: 40410.0000G

1 20

Page 13

The use of a damp cloth rinsed in any mild, non-abrasive, liquid detergent is recommended for cleaning all surfaces on Bunn-O-Matic equipment.

1.Remove the brew funnel.

2.Remove the sprayhead by turning it counterclockwise with your fingertips.

3.Disassemble sprayhead by removing rubber gasket.

4.Check the holes in the sprayhead. If plugged by lime, they may be cleared using a toothpick. Rinse the sprayhead with water.

5.Reassemble the sprayhead according to FIG 11. NOTE: Verify the indents are aligned. (ARROWS)

6.Reinstall the sprayhead by turning it clockwise. Hand tighten only!

FIG 12

FIG 11

Page 13	40410	092407

Image 13

Contents

Smart Wave Series BUNN-O-MATIC CORPORATIONINSTALLATION & OPERATING GUIDE SeriesPage BUNN-O-MATIC COMMERCIAL PRODUCT WARRANTYINTRODUCTION CONTENTSUSER NOTICES Switch SettingsCE REQUIREMENTS ELECTRICAL REQUIREMENTS230 VOLT CE Model 120/240 VOLT ModelPlumbing Hook-Up PLUMBING REQUIREMENTSINITIAL SET UP DO NOT USE FAUCET DURING BREW CYCLE COFFEE BREWINGFIG 6A B SMALL BREW SWITCH A ENABLE BREW ON/OFF SWITCHC LARGE BREW SWITCH Smart Wave Silver SeriesRestore Factory Defaults BREW VOLUME SET-UPPROGRAMMING - SILVER SERIES OPTIONAL PULSE BREW SET-UPC BREW B SWITCH + B BREW A SWITCHD HIDDEN PROGRAM SWITCH Enter E STATUS DISPLAY Smart Wave SeriesADJUST U7 FACTORY ADJUSTMENTSPROGRAMMING - SMART WAVE WITH DISPLAY ADVANCED SET-UPDELIMING CLEANING OPTIONAL LARGE SPRAYHEAD CLEANINGUnplug the brewer and let it cool down before proceeding Front Wrap COVER REMOVALTop Cover REMOVE7. After draining, reinstall hose and clamp. Hand tighten only DRAINING TANK1. Unplug the brewer and let it cool down before proceeding 2. Remove the brew funnel 3. Remove the front coverProgram Switches SWITCH SETTINGSNOTE All switches are turned OFF from factory KEY #DISPLAY TROUBLESHOOTINGDESCRIPTION ACTION2 WIRE + GND SCHEMATIC WIRING DIAGRAMSINGLE PHASE WAVE 15 APS, 15 S APSWAVE 120/240V APS SERIES SCHEMATIC WIRING DIAGRAM3 WIRE + GND SINGLE PHASE2 WIRE + GND SCHEMATIC WIRING DIAGRAMSINGLE PHASE WAVE 15 APS, 15 S APS