Bunn 40410.0000G service manual Cover Removal, Top Cover, Remove, Page

Models: 40410.0000G

1 20

Page 14

Front Wrap:

1.Remove the brew funnel.

2.Remove upper and lower screws on either side of front cover.

3.Loosen middle screw on either side of front cover.

4.Pull front cover towards front of brewer.

2.Lift top cover to clear front tabs.

REMOVE

LOOSEN

REMOVE

FIG 13

Page 14	40410	092407

Image 14

Contents

INSTALLATION & OPERATING GUIDE BUNN-O-MATIC CORPORATIONSmart Wave Series SeriesBUNN-O-MATIC COMMERCIAL PRODUCT WARRANTY PageUSER NOTICES CONTENTSINTRODUCTION Switch Settings230 VOLT CE Model ELECTRICAL REQUIREMENTSCE REQUIREMENTS 120/240 VOLT ModelPLUMBING REQUIREMENTS Plumbing Hook-UpINITIAL SET UP FIG 6A COFFEE BREWINGDO NOT USE FAUCET DURING BREW CYCLE C LARGE BREW SWITCH A ENABLE BREW ON/OFF SWITCHB SMALL BREW SWITCH Smart Wave Silver SeriesPROGRAMMING - SILVER SERIES BREW VOLUME SET-UPRestore Factory Defaults OPTIONAL PULSE BREW SET-UPD HIDDEN PROGRAM SWITCH Enter E STATUS DISPLAY B BREW A SWITCHC BREW B SWITCH + Smart Wave SeriesPROGRAMMING - SMART WAVE WITH DISPLAY U7 FACTORY ADJUSTMENTSADJUST ADVANCED SET-UPDELIMING CLEANING CLEANING OPTIONAL LARGE SPRAYHEADTop Cover COVER REMOVALUnplug the brewer and let it cool down before proceeding Front Wrap REMOVE1. Unplug the brewer and let it cool down before proceeding DRAINING TANK7. After draining, reinstall hose and clamp. Hand tighten only 2. Remove the brew funnel 3. Remove the front coverNOTE All switches are turned OFF from factory SWITCH SETTINGSProgram Switches KEY #DESCRIPTION TROUBLESHOOTINGDISPLAY ACTIONSINGLE PHASE SCHEMATIC WIRING DIAGRAM2 WIRE + GND WAVE 15 APS, 15 S APS3 WIRE + GND SCHEMATIC WIRING DIAGRAMWAVE 120/240V APS SERIES SINGLE PHASESINGLE PHASE SCHEMATIC WIRING DIAGRAM2 WIRE + GND WAVE 15 APS, 15 S APS