Bunn BTC, BT10 manual Brewing Delicious Coffee, Hot Water Use With Caution

BREWING DELICIOUS COFFEE

Step 1

Insert a BUNN® coffee filter into the brew funnel. Be sure to use BUNN® coffee filters for proper brewing. Order more paper filters direct from BUNN® at www.bunn.com

P2562

Step 2

Measure coffee into the filter and gently shake the filter to level the bed of grounds.To determine the amount of coffee to be used, see Page 8.

P2563

Step 3

Make sure that the sprayhead is tight. Slide the brew funnel into the brewer.

P2564

Step 4

Raise the hinged flip-lid and pour a carafe of water into the top of the brewer. See Brewing Tips (page 8) for pre- heating the carafe. Place the carafe on the brewer,THEN close the lid. Your BUNN® brewer will begin brewing coffee immediately. Flip-lid should also remain closed when brewer is not in operation.

Step 5

When brewing has stopped, remove the brew funnel and discard the filter and grounds. Do not touch hot grounds.

P2561

P215

NOTE:Opening the lid during brew cycle will interrupt the flow of water into the tank, but will not interrupt the brewing process.The brewed coffee already in the funnel will empty into the carafe.When lid is closed, the flow of water into the funnel will resume until the brewing cycle is complete.

WARNING: Do not close the lid after pouring in water, without the decanter in place. Closing the lid releases the hot water.

HOT WATER (USE WITH CAUTION)

The same basic steps can be used to obtain hot water by omitting the filter and coffee.The water from your BUNN® coffee brewer is approximately 200° F. This is hotter than the hot water from your faucet and must be handled

with care. 7