10.Slowly feed the door support arms through the slots located on the front of the Powder
11.Continue to slowly feed the door support arms through the slots until the magnet strikes on the back of the door engage the magnets on the Powder
12.Locate the
13.Place one brass spacer on each screw.
14.Insert one screw/spacer assembly through the door hinge, locating the spacer inside the hinge bushing and threading the screw into the hinge mount on the Powder
15.Install PAF level probe (BOM #29728.1000) by sliding it into the notched area at the top rear of the CDS hop- per. The probe should be firmly seated in the notch and touching the contact pin protruding from the front of the CDS cooling drum mount.
NOTE: At this point, it is important that the CDS machine is fully assembled according to the instructions outlined in the CDS Operating and Service Manual.
16.Place the assembled Powder
17.Connect the Powder
18.Attach a flexible water line to the .25” flare fitting on the back panel of the Powder
NOTE: A water strainer assembly
USER NOTICES
Carefully read and follow all notices on the equipment and in this manual. They were written for your protection. All notices are to be kept in good condition. Replace any unreadable or damaged labels.
This equipment must be installed to comply with the Basic Plumbing Code of the Building Officials and Code Administrators International, Inc. (BOCA) and the Food Service Sanitation Manual of the Food and Drug Administration (FDA). For models installed outside the U.S.A., comply with the applicable Plumbing /SanitationCode.
00656.0000
Push back until fully latched before removing or manually filling chilled product hopper.
34561.0000
00986.0000 |
3 | 29793 080102 |
|
