BibEMPTY Lockout, Hrs + | Bunn LCR-3 guide

PROGRAMMING (Continued)

LCD DISPLAY

BibEMPTY LOCKOUT

NO EXIT YES

BREW LOCKOUT ?

NO EXIT YES

ENERGY SAVER MODE

NO EXIT YES

E-SAVER IDLE TIME

(-) 4 HRS (+)

E-SAVER TANK TEMP

NO EXIT 140

ACTION

Select (YES) to enable

Select (YES) to enable

Select (ON) to enable

Use the (+) or (-) buttons to adjust the Idle Time

Select OFF or 140° F (60°C)

DESCRIPTION

Select YES to Lockout dispensing until the BIB is replaced and the pump has been Primed. Default is NO.

Select YES to Lockout dispensing until the hot water tank is at READY Temp. Default is NO.

Select ON to enable Energy Saver Mode. Default is OFF.

Enter the amount of inactive time before the dispenser goes into Energy Saver Mode. Default is 4 hrs. Maximum is 24 hrs.

Choose OFF to turn the tank heaters off completely or 140°F (60°C) to hold hot water at 140°F (60°C) during E-Saver Mode. Default is 140°F (60°C).

14	41129 071409

Image 14

Bunn LCR-3 service manual BibEMPTY Lockout, Hrs +, Saver Tank Temp No Exit Action

Contents

LCR-3 HV Phone 217 529-6601 FAX 217 BUNN-O-MATIC Commercial Product Warranty Contents Introduction User Notices Moving Parts Electrical Requirements Field Wiring Terminal Block Diagram Plumbing Requirements Plumbing HOOK-UP Initial SET-UPElectrical HOOK-UP Leveling the Dispenser Drip Tray Installation Operating Controls and Interface Initial Fill & Heat Alarm Level Alarm Mode Rinse Alarm FeatureRinse Procedure Energy Saver Mode BIB Empty Lockout FeatureBrew Temperature Lockout Feature Optional 2- Product Operation Programming the Dispenser Programming Saver Tank Temp No Exit Action BibEMPTY LockoutHRS + CAL HI WTR VOL LCD Display Actiondescription CAL Left Pump ? LeftCAL Middle Pump ? CAL MID Pump VOL LCD Display Xxoverflow WTR Start DelayWTR Stop Delay Test Refill ? Exit YES Test Heater ? Loading the Concentrate Priming the Concentrate Lines Filling Cambros or Other Large Containers Operating the DispenserTo Dispense Hot Water Weekly Sanitizing Cleaning & Preventative MaintenancePreventive Maintenance Weekly Refrigeration AIR Filter Replacing the Pump Tubing Draining the HOT Water Tank No Display TroubleshootingPossible Cause Troubleshooting Procedures Water TOO LOWHeating Check for BAD Connections Screen Displayed Possible Cause Calibrating the Left Concentrate Pump Dispenser Flow Rate Calibration Field Calibrating the Empty BIB Warning Schematic Wiring Diagram