DRAINING THE HOT WATER TANK
CAUTION: The dispenser must be disconnected from the power source throughout these steps.
1.Disconnect the dispenser from the power source.
2.Shut off and disconnect the incoming water supply.
3.Remove the lower right access panel.
4.Pull out drain tube to empty into a sink or a container with a minimum of 18 gallon capacity.
5.Make sure drain clamp is closed. Then, remove drain plug.
6.Direct tube into sink or container and open drain clamp. Continue draining tank until ALL of the water is
out.
CAUTION: The water may be very hot as it drains out of the tank. Make sure the hose is directed away from the body.
7.Close drain clamp, insert drain plug, place drain tube back into machine, and replace the access panel. Note: The dispenser must be refilled using the Initial Fill & Heat steps before reconnecting the power source.
21 | 41129 052208 |
|
