Bunn RL00006929 service manual Service Indicator Lamps, See below

SERVICE (cont.)

Indicator Lamp(s)

P1712

FIG. 15 INDICATOR LAMPS - MODEL OL

P1713

FIG. 16 INDICATOR LAMP - MODEL RL

Location:

The indicator lamps are located beneath their associ- ated warmers, FIG.s 15 and 16.

Test Procedure:

1.Check continuity of the black wire from the switch to the indicator lamp.

2.Check continuity of the white or red wire from the indicator lamp to the terminal block.

If continuity is present, proceed to #3.

If continuity is not present, refer to Wiring Diagrams and check brewer wiring harness.

3.Check for voltage across the indicator lamp ter- minals. Connect the brewer to the power source. The indication must be:

a)120 volts ac for two wire 120 volt models and three wire 120/240 volt models.

b)200 or 240 volts ac for two wire 200 volt or 240 volt models.

c)100 volts ac for two wire 100 volt models.

4.Disconnect the brewer from the power source.

If voltage is present, the indicator lamp is operating properly.

If voltage is not present, replace the indicator lamp.

Removal and Replacement:

1.Compress the clips inside the housing and gently push the indicator lamp through the opening.

2.Remove the wires from the indicator lamp termi- nals.

3.Refer to FIG. 17 when reconnecting the wires.

4.Push the new indicator lamp firmly into the opening.

WHI or RED

(see below)

BLK (see below)

P1694

FIG. 17 INDICATOR LAMP WIRING

MODEL
OL Upper	BLK	to Warmer Switch
	WHI or RED	to Warmer
		to Harness P2
OL Lower	BLK	to On/Off Brew Station Warmer
		Switch
	WHI or RED	to Relay P2
		to Brew Station Warmer
RL	BLK	to On/Off Brew Station Warmer
		Switch
	WHI or RED	to Right Front Warmer
		to Left Front Warmer

Page 19 32430 121699