PROGRAMMING THE BREWER (cont.)
COPY SETTINGS (NO NAME COFFEE SETTINGS ONLY) (cont.)
2.Press YES in this screen. The display should read LEFT
3.If the initial programming was done on the left side of the brewer, press YES. The display will read ARE
YOU SURE?
4.If you are sure that the data should be transferred from left to right, press YES. The display will then read TRANSFER COMPLETE, and will automatically advance to the next function screen.
5.In the LEFT
6.If the initial programming was done on the right side of the brewer, press YES. The display will read
ARE YOU SURE?
7.If the data should be transferred from right to left, press YES. After the data is transferred, the display will read TRANSFER COMPLETE. This will appear for 3 seconds, then will exit to the next function screen. Brew settings for all flavors are not the same on both sides of the brewer, only the NO NAME setting has been transferred.
ENABLE ADS?
This function allows the operator to choose whether or not to display the advertising message that was en- tered into the brewer with an AD CARD. This message will be displayed when the brewer is not in use.
ENABLE ADS ?
NO DONE YES
Procedure to Enable/Disable Ads:
1.Press and hold upper right hidden switch until the display reads UNITS. Release switch. Continue to press and release switch until the display reads ENABLE ADS. The YES or NO will be flashing to indicate the current selection.
2.Press and release the NO to disable this function (no ads will be displayed on the screen), or;
3.Press and release the YES to enable this function (ads will be displayed on screen).
4.When finished, press and release DONE to save the new setting, exit the ENABLE ADS function and advance to the next function screen, SET TEMP. Another alternative is to press and release the ON/OFF switch (either on DUAL brewers) located on the front switch panel to exit the ENABLE ADS function and return to the MAIN SCREEN.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
° |
| ° | ° | ° | |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
SET TEMP - Range: 185˚F (85˚C) to 205˚F (96˚C) This function allows the operator to set the brew
water temperature in the tank. It also sets the hot water faucet dispense temperature.
SET TEMP: XXX° (-) DONE (+)
Procedure to set brew temperature:
1.Press and hold upper right hidden switch until the display reads UNITS. Release switch. Continue to press and release switch until the display reads
SET TEMP.
Page 27 | 41341 080108 |
|
