USER NOTICES
Carefully read and follow all notices on the equipment and in this manual. They were written for your protec- tion. All notices on the equipment should be kept in good condition. Replace any unreadable or damaged labels.
#00831.0000 | #37881.0000 |
!WARNING
Fill water tank before turning - on - thermostat or connecting appliance to power source.
Use only on a properly protected circuit capable of the rated load.
Electrically ground the chassis.
Follow national/local electrical codes. Do not use near combustibles.
FAILURE TO COMPLY RISKS EQUIPMENTDAMAGE, FIRE, OR SHOCK HAZARD
READ THE ENTIRE OPERATING MANUALBEFORE BUYING OR USING THIS PRODUCT
THIS APPLIANCE IS HEATED WHENEVERCONNECTED TO A POWER SOURCE
00831.0000F 3/98 ©1998
#03408.0000
#03409.0000
#00656.0000
#03537.0000
#26371.0000#26371.0001
WATER SWEETENER
INLET INLET
To reduce the risk of electric shock, do not remove or open cover.
No
#06064.0000
WARNING
•FILL WATER TANK BEFORE ENERGIZING
•DO NOT OVERLOAD CIRCUIT
•KEEP AWAY FROM COMBUSTIBLES
•DO NOT DEFORM PLUG OR CORD
SEEINSTRUCTIONS
•FAILURE TO COMPLY RISKS EQUIPMENT DAMAGE, FIRE OR SHOCK
•BREWER ENERGIZED UNLESS UNPLUGGED
#32540.0000
BREWERSTIMER SETTING
CAUTION – Disconnect the power source from the brewer prior to the removal of any panel for the replacement or adjustment of any component.
NOTE: Check that the brewer is connected to water supply, the tank is properly filled, and a funnel and server are in place, prior to setting or modifying batch sizes.
1.Modifying batch sizes. To modify a batch volume, first check that the SET/ LOCK switch is in the “SET” position on the circuit board. If the brewer has a batch selector switch, position it to the size to be changed.
To increase a batch size, Press and hold the START or BREW switch until three clicks are heard. Release the switch and then press it again one or more times. Each time the switch is pressed, two seconds are added to the brew time period. Allow the brew cycle to finish in order to verify that the desired volume has been achieved.
To decrease a batch size, Press and release the START or BREW switch once for every
2.Setting batch sizes. To set a batch volume, first check that the SET/LOCK switch is in the “SET” position on the circuit board. Press and hold the START or BREW switch until three distinct clicks are heard (this will take approximately ten seconds), and then release the switch. (Failure to re- lease the switch within two seconds from the third click causes the volume setting to be aborted). View the level of the liquid being dispensed. When the desired level is reached, turn the ON/OFF switch to “OFF”. The brewer remembers this volume and will continue to brew batches of this size until
the volume setting procedure is repeated. Empty server(s), turn selector switch to positions that have yet to be set, and repeat batch setting proce- dure until all batch sizes are set.
NOTE: When brewing coffee, batch volumes will decrease due to absorption by the coffee grounds.
32540.0000C 09/01 ©1999
Page 3 | 37236 050305 |
|