SERVICE
This section provides procedures for testing and replacing various major components used in this brewer should service become necessary. Refer to Troubleshooting for assistance in determining the cause of any problem.
WARNING - Inspection, testing, and repair of electri- cal equipment should be performed only by qualified service personnel. The brewer should be disconnected from the power source when servicing, except when electrical tests are required and the test procedure spe- cifically states to plug in the brewer.
COMPONENT ACCESS
WARNING - Disconnect the brewer from the power source before the removal of any panel or the replace- ment of any component.
All components are accessible by the removal of the top cover and rear inspection panel.
The top cover is attached with four
The rear inspection panel is attached with six #8- 32 screws. Removal of the rear panel will allow access to the brew solenoid valves and the dilution solenoid valve .222 GPM flow control and check valve.
FIG. 1 COMPONENT ACCESS | P1370.40 |
|
Contents |
|
|
|
Brew Solenoid Valve (Hot Tea) | 15 |
|
|
Brew Solenoid Valve (Iced Tea) | 16 |
|
|
Brew Timer (Hot Tea) (Early Models) | 17 |
|
|
Digital Brew Timer (Hot Tea )(Late Models) | 18 |
|
|
Brew Timer (Iced Tea) (Early Models) | 20 |
|
|
Digital Brew Timer (Iced Tea)(Late Models | 21 |
|
|
Control Thermostat | 23 |
|
|
Dilution Solenoid Valve | 24 |
|
|
Limit Thermostat | 25 |
|
|
ICED/OFF/HOT Switch | 26 |
|
|
Start Switch | 27 |
|
|
Tank Heater | 28 |
|
|
Thermal Fuse | 29 |
|
|
Wiring Diagrams | 30 | 28201 | 081500 |
| Page 14 | ||
|
|
|
