Bunn TNTF-3 Cleaning, Operating Controls, Brewing, A. ICED/OFF/HOT Switch, B. Start Switch

Models: TNTF-3

1 30
Download 30 pages 36.83 Kb
Page 7
Image 7

CLEANING

CAUTION – Do not keep brewed tea overnight. Clean and sanitize your iced tea dispenser daily

1.Remove and thoroughly clean the brew funnel. The funnel tip and screen must be free from any tea particles or residue. Reassemble the funnel.

2.Unplug the brewer. Remove and thoroughly rinse the sprayhead. The holes must be open and clear of any mineral deposits. Wipe the sprayhead panel clean with a damp cloth.

3.Insert the deliming spring into the sprayhead fitting until no more than one inch is visible and move it in and out 5 or 6 times. Insert the spring into the airvent hole in the sprayhead panel and move it in and out 5 or 6 times. Reattach the sprayhead.

4.Wash the entire outside surface of the brewer with a clean damp cloth.

OPERATING CONTROLS

A.ICED/OFF/HOT Switch

ICED – Placing the switch in the left position allows the start switch to activate a timed brew cycle delivering

.5 gallon of tea concentrate and 2.5 gallons of dilution water into the dispenser.

OFF – Placing the switch in the center position stops the brew cycle. Stopping a brew cycle after it has started will not stop the flow of water into the funnel until the tank syphons down to its level. The switch should always be placed in this position after a brew cycle and whenever the brewer is unattended.

HOT – Placing the switch in the right position allows the start switch to activate a timed brew cycle delivering

.5 gallon of hot tea into an airpot dispenser.

B.Start Switch

Starts a brew cycle when the ICED/OFF/HOT switch is in either the “ICED” or “HOT” position.

BREWING

1.Begin brewing with a clean empty brew funnel and dispenser. (Be sure the dispenser is open.)

2.Insert a BUNN® filter into the funnel.

3.Pour the fresh loose tea leaves into the filter.

4.Level the bed of tea leaves by gently shaking.

5.Slide the funnel into the funnel rails until it stops.

6.Place the ICED/OFF/HOT switch in the desired position.

7.Momentarily press the start switch.

8.Carefully remove the brew funnel and discard its contents after liquid stops flowing from the funnel. CAUTION – The funnel contains hot liquid. Remove funnel slowly.

9.Place the ICED/OFF/HOT switch in the “OFF” position to prevent a false start.

Page 7

28201 081500

Page 7
Image 7
Bunn TNTF-3 service manual Cleaning, Operating Controls, Brewing, A. ICED/OFF/HOT Switch, B. Start Switch