Burley HD 4485/86/87, HD 4435/36/37 warranty Single Passenger, Ladder Lock

The straps and sliding buckles sewn to the backrest of the child seat are part of a self-adjusting system that keeps the shoulder straps at the correct height for children of various sizes. When you tighten the shoulder harness, the sliding buckles allow the shoulder belts to come across the top of the child’s shoulders, creating a snug fit. In addition, the sliding buckles keep the straps from falling off of the shoulders.

IMPORTANT: Always fasten and adjust the two buckles behind the child seat when using the trailer.

Single Passenger:

Ladder Lock

10

1.Remove both shoulder harnesses from the shoulder straps (see Section VI for details on removing the shoulder harness). Unclip the Y-buckle if necessary. Store one of the shoulder harnesses in a safe place. Leave outboard shoulder straps dangling. Do not unthread the straps from the ladder locks in this step.

2.Remove the two center shoulder straps by unthreading them from the ladder locks.

3.Trade the position of the shoulder straps and re-insert the straps into the ladder locks as shown in the illustration. The flat parts of the male portion of the Y-buckle should face toward the center.

4.Install one shoulder harness assembly in the center position as shown

below. See Section VI for details on installing the shoulder harness.

5.Seat the child in the center of the seat.

6.Snap in the shoulder straps at the Y-buckle. Ensure that the Y-buckle is adjusted so that it is at the child’s sternum.

7.Ensure that the shoulder straps are adjusted so that the child is comfortably kept from moving too far forward in the seat.

8.Fasten and adjust lap belt so that it is snug.

Burley Cub Owner’s Instruction and Safety Manual